This article covers the Payloader BC2, BC3, BC4
TOE-IN ADJUSTMENT
1. Raise vehicle and remove front wheel assemblies.
2. Depending on the vehicle, measure the distance between
the front hub assemblies or the front rotor/brake
assemblies. Measurements are to be made in
the middle, front, and rear edges of the assemblies.
Difference between the two measurements should not exceed 1/16”.
3. If adjustment is required, loosen the jam nuts on the front
tie rod tube and rotate the tube to achieve the correct
measurement. Apply blue Lock-Tite to the threads and
re-tighten jam nuts when complete.